Page 1 of 1

After Plate Solve -- Move mounting?

Posted: Sun Dec 24, 2017 2:41 pm
by StarManFlorida
I have read and read the manual, but could not find the answer:

Another software can after a plate solve move the mounting to the exact RA and Dec I originally wanted. Does Prism have this capability too ??? If so, what page in the manual ??


Re: After Plate Solve -- Move mounting?

Posted: Tue Dec 26, 2017 11:39 am
by Hamza Touhami
Good morning Frank

Automatic centering is part of the automatic observation and It can be easily done by hand. In Auto Obs. Prism slew to the selected target > takes an image > plate solves > calculates the offset > slews to the new coordinates > plate solves to ensure centering. In the manual mode, you can take an image and solve and sync and the skychart will update with the exact coordinates. We have a few enhancements on our to do list that our customers will really like.


Re: After Plate Solve -- Move mounting?

Posted: Fri Jun 22, 2018 3:44 pm
by StarManFlorida
Thank you... I found it. I guess I need a reading course.

Thanks... Frank