Communication issue ASCOM ioptron PrismV10

CCD cameras (CMOS/CCD), DSLRs, telescope mounts, focusers, autoguiders, domes, Roll off roofs, etc..
Post Reply
Posts: 12
Joined: Tue Apr 17, 2018 11:33 pm

Sun Mar 24, 2019 7:13 am


I've installed my brand new Cem120ec2 and connected it to prism. The telescope is in a horizontal parking position and my skchart shows that what you can see in the attached image. What happens there? The telescope is virtually jumping around. If I'am looking for an object and slew to then everything is working perfect. Only the shown telescope position in the sky chart is jumping around like crazy. Any suggestions? The encoders are calibrated.

Screenshot_20190324-145054_Remote Ripple.jpg
Hamza Touhami
Site Admin
Posts: 564
Joined: Sat May 20, 2017 6:05 pm
Location: Phoenix,AZ

Mon Mar 25, 2019 7:44 pm

PRISM displays what the driver is telling it, so basically it puts on the map where the driver says. However, we need to investigate. I need a log. Can you please start PRISM turn on the log under settings > log file then check the box "Enable PRISM log". Send me the file via email please. We have a lot of customers using iOption mounts successfully.
Hamza Touhami | Site Administrator
Post Reply