Need Tips for Slit Guiding

Calibration tools, stacking, aligning,..
Post Reply
User avatar
Vkagnihotri
Posts: 48
Joined: Sun Sep 17, 2017 11:21 pm
Location: Kota, India
Contact:

Sun Feb 18, 2018 12:27 am

Hello Friends
Good morning

I set up the Aply600 spectroscope + ZWO120mm guide cam. May I expect help to fix slit guiding parameters using PRiSM.
Instrument and slit view can be seen in image attached.
Aply600.jpg
Note: updated ZWO drivers as old drivers had issue with PRISM (may be some other problem).
PRiSM behaved well with new drivers. These are @ ZWO website:
ZWO ASI Cameras driver Setup V3.0.0.3
ASICamera ASCOM Setup V1.0.3.15

Regards
Vikrant
Cyril Cavadore
Site Admin
Posts: 74
Joined: Sat May 20, 2017 6:15 pm

Sun Nov 18, 2018 5:33 pm

May I expect help to fix slit guiding parameters using PRiSM.
What do you except ? Support on the fact that the slit lies horizontaly ? Could you please be more accurate ?
Cyril Cavadore
Principal Prism Author,
Alcor-System
www.alcor-system.com
keving
Posts: 53
Joined: Thu Dec 14, 2017 4:49 am

Sun Dec 02, 2018 2:08 pm

Hi

I am using Prism with a LhiresIII (another spectroscope from Shelyak) but I also have an Alpy (although last time I used it I wasnt using Prism...)
I am also happy to help, but, as Cyril said, it might help us if you can give a specific question...
I assume you have been through all the Alpy tutorials available online (I think Shelyak do quite a few)?

Prism has slit-guiding (under advanced tab) which I use for my Lhires but you dont have to use this at first if you are more familar with normal guiding. It will work.

Kevin
Post Reply