First capture with Prism - M101

Use this section to showcase your successes using Prism
Post Reply
Posts: 126
Joined: Thu Aug 23, 2018 8:22 pm
Location: Missouri, USA

Tue May 14, 2019 9:41 pm

Well I suppose I might as well post it since it's a result.... :oops:


So this is about 1.8 hours of data. I messed up my session (I have some question threads outstanding about that).

Here are some details, all frames were 300sec (5Min) shot on my ZWO1600mm-cool Gen 2, at HDR (Gain 0) from a Red zone.

Since I haven't learned Prism well enough yet I ended up pre-processing and stacking using Prism, then I converted the CPA files to FITS and imported the "master" result frames to Pixinsight. From there I used Pixel Math and I added these 3 together to make a "super luminance" frame, then I used the Lum master as the Blue channel. Then I put the image through my normal workflow in Pi.

I have to say I cannot wait to learn more about processing with Prism, the calibration and stacking process was SUPER EASY and gave me great results for the data I have at hand (this data set is very poor, the focus was off, I didn't get data for a whole channel, etc.)

I think this result turned out pretty amazing considering the challenge of this dataset.
Hamza Touhami
Site Admin
Posts: 547
Joined: Sat May 20, 2017 6:05 pm
Location: Phoenix,AZ

Fri May 17, 2019 9:46 am

I think you're right, that is a great start
Hamza Touhami | Site Administrator
Joe in Mobile
Posts: 6
Joined: Tue Oct 22, 2019 8:50 am

Wed Nov 20, 2019 7:17 pm

Nicely done.

Joe in Mobile
Post Reply