pointing model failure

Hardware and software setups, autoguiding and plate solving parameters, etc..
Post Reply
amstpils
Posts: 18
Joined: Mon Nov 12, 2018 12:53 pm

Fri Feb 07, 2020 12:00 pm

I have tried twice to create a pointing model and both times I have aborted the model because of the low success rate plate solving.
The first time it only solved about 20% of the points and the second it didn't solve any..
I currently plate solve with a ZWO 120 and a 9x50 Celestron finder scope. For the pointing model I am using an STF8300 on a C-11 at f/10.
The pointing model doesn't ask for any camera pixel size or array or focal length info, or direct you to supply this information using the analysis / plate solve menu.
If it is using this information, it will not get good results since the analysis / plate solve is set up for the finder.

any thoughts

Al Stiewing
Hamza Touhami
Site Admin
Posts: 552
Joined: Sat May 20, 2017 6:05 pm
Location: Phoenix,AZ
Contact:

Sat Feb 08, 2020 1:26 pm

can you please post screenshots of the settings you used? I am sure it is something that can be resolved
Hamza Touhami | Site Administrator
Hyperion-Astronomy.com
Post Reply